Scale Figure Care: 1/7 and 1/4 PVC and Resin Basics

Quick answer

Clean 1/7 and 1/4 scale figures every 4–8 weeks with a soft brush and lukewarm water only when needed, keep them out of direct sunlight, and support large figures at the base to prevent leaning. Avoid alcohol, acetone, and abrasive cloths on painted or glossy surfaces.

Step-by-step scale figure care routine

1. Set up a clean, stable workspace: Clear a table, lay down a clean microfiber cloth, and wash your hands before touching the figure. Common mistake: handling the figure over a hard floor or near the edge of a shelf, where a dropped part can chip or shatter. Work at waist height with a soft landing zone under the figure.
2. Remove dust with a soft brush, top to bottom: Use a clean, dry cosmetic brush or a camera lens blower to lift dust from the head and shoulders downward. For tight crevices, use a dry cotton swab. Common mistake: brushing upward or pressing hard, which pushes dust into joints and can dull glossy paint. Brush in one direction and let the brush do the work, not pressure.
3. Spot-clean only where needed: Dampen a microfiber cloth with lukewarm water and wring it out until barely wet. Wipe a small area, then dry immediately with a dry cloth. Common mistake: using alcohol, acetone, or glass cleaner, which can strip paint or cloud clear parts. If the cloth leaves a visible wet streak, it is too wet.
4. Treat fabric and delicate details separately: For real net tights or fabric elements, use a squeeze bulb or low-suction vacuum held at a distance rather than a brush. Common mistake: brushing fabric directly, which can pull threads or leave fuzz. If a thread snags, stop and use tweezers, not your fingers.
5. Check stability and support: Place the figure on a level shelf and confirm the base sits flat. For 1/4 scale figures, use the supplied stand or a clear support under an extended limb if the pose leans. Common mistake: displaying a heavy figure on a narrow shelf or near a door where vibration can tip it. A figure that wobbles when nudged needs a wider base or a support.
6. Manage display lighting: Keep figures out of direct sunlight and use LED lighting with low heat output. Position lights so they do not shine directly on glossy paint for hours, which can highlight dust and slowly fade colors. Common mistake: using halogen or incandescent lamps close to the figure. If the shelf feels warm to the touch, move the light farther away.
7. Store or rotate carefully: When storing, wrap the figure in acid-free tissue or a clean cotton cloth and place it in a rigid box with padding. Do not store heavy figures under other boxes. Common mistake: sealing a figure in a plastic bag while slightly damp, which can trap moisture. Label the box and store it flat, not on its side.

Product-specific care notes

• GOBLIN SLAYER - Priestess: Bunny Ver. 1/4 Scale Figure: Priestess: Bunny Ver. is a 1/4 scale figure with glossy paintwork and real net tights. The glossy finish shows fingerprints and smears easily, and the real net tights can snag, so use a soft brush and avoid wet wiping on the fabric.